Added pcb

README.md

@@ -1,7 +1,7 @@
 # OpenFlops
 OpenFlops is an Open Hardware Floppy Disk Drive emulator/simulator.
 
-![Board](https://raw.githubusercontent.com/SukkoPera/OpenFlops/master/img/render-top.png)
+![Board](https://git.sweproj.com/ABC80/SweFlops/raw/master/img/Gotek.png)
 
 ### Summary
 From [Wikipedia](https://en.wikipedia.org/wiki/Floppy_disk_hardware_emulator):
@@ -9,7 +9,7 @@ From [Wikipedia](https://en.wikipedia.org/wiki/Floppy_disk_hardware_emulator):
 
 > Floppy disks and floppy drives are gradually going out of production, and replacement of malfunctioning drives, and the systems hosting them, is becoming increasingly difficult. Floppy disks themselves are fragile, or may need to be replaced often. An alternative is to use a floppy disk hardware emulator, a device which appears to be a standard floppy drive to the old equipment by interfacing directly to the floppy disk controller, while storing data in another medium such as a USB thumb drive, Secure Digital card, or a shared drive on a computer network. Emulators can also be used as a higher-performance replacement for mechanical floppy disk drives. 
 
-OpenFlops is an Open Hardware implementation of such an emulator, inspired from the ubiquitous Gotek hardware. It is designed to run the [FlashFloppy](https://github.com/keirf/FlashFloppy) firmware, which gives it several improvements over the original Gotek:
+SweFlops is an Open Hardware implementation of such an emulator, inspired from the ubiquitous Gotek hardware. It is designed to run the [FlashFloppy](https://github.com/keirf/FlashFloppy) firmware, which gives it several improvements over the original Gotek:
 - Can be installed on [many different platforms](https://github.com/keirf/FlashFloppy/wiki/Host-Platforms)
 - Directly supports a [wide range of image formats](https://github.com/keirf/FlashFloppy/wiki/Image-Formats)
 - [Flexible track layout](https://github.com/keirf/FlashFloppy/wiki/Track-Layouts) for Raw Sector Images

SweFlops.kicad_pcb

@@ -6717,6 +6717,11 @@
       (scale (xyz 1 1 1))
       (rotate (xyz 0 0 0))
     )
+    (model "${KIPRJMOD}/3d-models/Tactal Switch -Thru (6mmx 6mmx4.3mm).stp"
+      (offset (xyz 4 -2 0))
+      (scale (xyz 1 1 1))
+      (rotate (xyz 0 0 0))
+    )
   )
 
   (footprint "Resistor_SMD:R_0402_1005Metric" (layer "F.Cu")