|
|
@@ -191,7 +191,7 @@ Ground -------------------------- coax signal ground
|
|
|
The NVS parameter "display_config" sets the parameters for an optional display. Syntax is
|
|
|
```
|
|
|
I2C,width=<pixels>,height=<pixels>[address=<i2c_address>][,reset=<gpio>][,HFlip][,VFlip][driver=SSD1306|SSD1326[:1|4]|SSD1327|SH1106]
|
|
|
-SPI,width=<pixels>,height=<pixels>,cs=<gpio>[,back=<gpio>][,reset=<gpio>][,speed=<speed>][,HFlip][,VFlip][driver=SSD1306|SSD1322|SSD1326[:1|4]|SSD1327|SH1106|SSD1675|ST7735[:x=][:y=]|ST7789|ILI9341[:16|18][,rotate]]
|
|
|
+SPI,width=<pixels>,height=<pixels>,cs=<gpio>[,back=<gpio>][,reset=<gpio>][,speed=<speed>][,HFlip][,VFlip][driver=SSD1306|SSD1322|SSD1326[:1|4]|SSD1327|SH1106|SSD1675|ST7735[:x=<offset>][:y=<offset>]|ST7789|ILI9341[:16|18][,rotate]]
|
|
|
```
|
|
|
- back: a LED backlight used by some older devices (ST7735). It is PWM controlled for brightness
|
|
|
- reset: some display have a reset pin that is should normally be pulled up if unused
|
philippe44