|
|
@@ -148,7 +148,7 @@ bck=<gpio>,ws=<gpio>,do=<gpio>[,mck][,mute=<gpio>[:0|1][,model=TAS57xx|TAS5713|A
|
|
|
```
|
|
|
if "model" is not set or is not recognized, then default "I2S" is used. The option "mck" is used for some codecs that require a master clock (although they should not). Only GPIO0 can be used as MCLK and be aware that this cannot coexit with RMII Ethernet (see ethernet section below). I2C parameters are optional and only needed if your DAC requires an I2C control (See 'dac_controlset' below). Note that "i2c" parameters are decimal, hex notation is not allowed.
|
|
|
|
|
|
-So far, TAS75xx, TAS5714, AC101 and ES8388 are recognized models where the proper init sequence/volume/power controls are sent. For other codecs that might require an I2C commands, please use the parameter "dac_controlset" that allows definition of simple commands to be sent over i2c for init, power on and off using a JSON syntax:
|
|
|
+So far, TAS57xx, TAS5713, AC101, WM8978 and ES8388 are recognized models where the proper init sequence/volume/power controls are sent. For other codecs that might require an I2C commands, please use the parameter "dac_controlset" that allows definition of simple commands to be sent over i2c for init, power on and off using a JSON syntax:
|
|
|
```
|
|
|
{ init: [ {"reg":<register>,"val":<value>,"mode":<nothing>|"or"|"and"}, ... {{"reg":<register>,"val":<value>,"mode":<nothing>|"or"|"and"} ],
|
|
|
poweron: [ {"reg":<register>,"val":<value>,"mode":<nothing>|"or"|"and"}, ... {{"reg":<register>,"val":<value>,"mode":<nothing>|"or"|"and"} ],
|
philippe44