
# Build Your Own

These instructions will guide you thorugh purchasing all of the parts needed to assemble kits for yourselves and for friends! Please note the hardware is licensed non-comercial.

If you'd like to buy the kits pre-packaged/pre-flashed or fully assembled we have a network of makers here to help you out at https://scsi.blue

## Order Parts

Updated for 1.0-c.

### PCB's

Grab the latest Gerbers. Gerber files tell the PCB manufactuer how to create the BlueSCSI boards.

https://github.com/erichelgeson/BlueSCSI/tree/main/hw/gerbers

Order the boards from https://jlcpcb.com/ or your manufactuer of choice.

### Components

#### Version 1.0-b & 1.0-c BOM

STM32F103C8T6 (U1) aka BluePill board. Beware of fake/scams. Look for reviews. Amazon, ebay, etc.

* 2x 330 (RN2, RN4) Resistor nets https://www.mouser.com/ProductDetail/652-4610X-1LF-330

* 2x 220 (RN1, RN3) Resistor nets https://www.mouser.com/ProductDetail/652-4610X-1LF-220

* 2x Diodes https://www.mouser.com/ProductDetail/583-1N5818-T

* SD Card Holder (J1)  https://www.mouser.com/ProductDetail/538-104031-0811

* Headers https://www.mouser.com/ProductDetail/872-920-0011-01

* 50 PIN SCSI header https://www.mouser.com/ProductDetail/517-30350-6002/
  - May substitute with 2 rows of headers from above.
  - **Note on Right angle connectors** - it appears Right angle headers are notched differently then the pin out. Be sure to note PIN 1/red stripe on the cable match up.

#### Optional

Floppy/Berg Power header https://www.mouser.com/ProductDetail/571-1718254
  - Required if your machine does not supply power via TERM POWER. For example a Mac Plus or Mac with a Analog/PSU board that has not been recapped.

### BluePill

Beware of fakes and buy from a place where returns are easy. Ensure the photo in the listing shows a chip that says STM32 on it.

https://www.amazon.com/s?k=stm32f103c8t6

https://www.ebay.com/sch/i.html?_nkw=stm32f103c8t6

### STlinkV2

You can usually find these bundled with the bluepill or at the same store you bought your bluepill. 

## Assemble

Follow the guide on component orientation and assembly.

https://github.com/erichelgeson/BlueSCSI/blob/main/docs/assembly.md

## 3D Case

Print or order a 3D case for your BlueSCSI to mount it inside your computer.

https://github.com/erichelgeson/BlueSCSI/tree/main/3D-Files

## Flash

You will need to flash the BlueSCSI program onto your BluePill following these instructions.

https://github.com/erichelgeson/BlueSCSI#flashing

## Usage

Be sure to follow the usage instructions for getting your drive images setup:

https://github.com/erichelgeson/BlueSCSI#usage
