| 12345678910111213141516171819202122232425262728293031323334353637383940414243444546 |
- ; RP2040 PIO program for accelerating SCSI communication
- ; Run "pioasm scsi_accel.pio scsi_accel.pio.h" to regenerate the C header from this.
- ; GPIO mapping:
- ; - 0-7: DB0-DB7
- ; - 8: DBP
- ; Side set is REQ pin
- .define REQ 9
- .define ACK 10
- ; Delay from data setup to REQ assertion.
- ; deskew delay + cable skew delay = 55 ns minimum
- ; One clock cycle is 8 ns => delay 7 clocks
- .define REQ_DLY 7
- ; Write to SCSI bus using asynchronous handshake.
- ; Data is written as 16-bit words that contain the 8 data bits + 1 parity bit.
- ; 7 bits in each word are discarded.
- ; Number of bytes to send must be multiple of 2.
- .program scsi_accel_async_write
- .side_set 1
- pull ifempty block side 1 ; Get data from TX FIFO
- out pins, 9 side 1 ; Write data and parity bit
- out null, 7 [REQ_DLY-2] side 1 ; Discard unused bits, wait for data preset time
- wait 1 gpio ACK side 1 ; Wait for ACK to be inactive
- wait 0 gpio ACK side 0 ; Assert REQ, wait for ACK low
- ; Read from SCSI bus using asynchronous handshake.
- ; Data is returned as 16-bit words that contain the 8 data bits + 1 parity bit.
- ; Number of bytes to receive minus 1 should be written to TX fifo.
- ; Number of bytes to receive must be divisible by 2.
- .program scsi_accel_async_read
- .side_set 1
- pull block side 1 ; Get number of bytes to receive
- mov x, osr side 1 ; Store to counter X
- start:
- wait 1 gpio ACK side 1 ; Wait for ACK high
- wait 0 gpio ACK side 0 ; Assert REQ, wait for ACK low
- in pins, 9 side 1 ; Deassert REQ, read GPIO
- in null, 7 side 1 ; Padding bits
- push iffull block side 1 ; Put data to RX FIFO
- jmp x-- start side 1 ; Decrement byte count and jump to start
|
