| 123456789101112131415161718192021222324252627 |
- # BlueSCSI 1.0-b to 1.0-c
- :toc: macro
- ## Introduction
- 1.0-c was a small change to fix an issue with machines that provide low or no `TERMPOWER` over the SCSI bus. If you received a fully-assembled BlueSCSI after April 1st, 2021 then this was done for you. If you have a kit labeled 1.0-b you can make these modifications to become a 1.0-c.
- ## Steps
- ### Disconnect `TERMPOWER` from 220 Pull Up Jumper
- Use a cutting tool to cut the small trace between the `TERMPOWR` and 220 Pull Up Jumper pictured below.
- Make sure continuity from `TERMPOWER` to the diode still flows correctly but is disconnected from the jumper.
- image::images/1.0-b-bodge-1.jpg[]
- ### Connect 5V to 220 Pull Up Jumper
- Now we will provide pull up from the 5V provided by the BluePill.
- image::images/1.0-b-bodge-2.png[]
- ### Complete!
- That’s it! 5V to the Pull Up resistors will now work when powered externally.
|
